CAMPAGNOLA POWER ECO PLUG-IN Manuel D'utilisation Et D'entretien page 94

After dismantling the product, the various materials must be separated and disposed of in accordance with the
regulations of the country in which the product is to be disposed of.
The operations described below are only permitted to authorised personnel:
Create sufficient space around the product to perform all movements without risk to personnel;
•
Disconnect the product's power sources.
•
Only after the above activities have been carried out, proceed to disassemble the product from top down and paying
special attention to the assemblies subject to falling by gravity.
Remove moving parts and separate, as far as possible, the various components by type of material (plastic,
•
metal, etc.), which must be disposed of through separate collection. Entrust the disposal of demolition
materials to the companies in charge.
Remove and handle the various parts of the product from the work area taking all necessary precautions
•
Always use the appropriate PPE for such operations and as indicated in Chapter 4.
•
After disassembling the product according to the previous procedure, the various materials must be
separated and disposed of in accordance with the regulations of the country in which the product is to be
disposed of. The product contains no hazardous components or substances requiring special removal
procedures.
CAUTION
Extreme care must be taken because the possible falling of parts or components during removal can pose a
serious danger to operators.
NOTE
Disposal must be carried out in accordance with the legislation of the country in which the product is installed. It
is the user's obligation to comply with the regulations in force in his country.
NOTE
In the event of difficulties in the disassembly, demolition and dismantling of the components making up the
product, consult CAMPAGNOLA S.r.l.'s design office, which will indicate the operating methods in compliance
with the principles of safety and environmental protection.
Please also refer to Chapter 4 regarding section "4.2.1 INDICATIONS FOR SPECIAL WASTE"
5.5.1 ADDITIONAL INFORMATION FOR BATTERY DISPOSAL
NOTE: For products equipped with battery packs or battery systems, please refer to the specific
documentation for their decommissioning or disposal.
6. USE AND OPERATION
6.1 GENERAL INFORMATION
- Only use the tool in good visibility conditions. A dimly lit work area may cause accidents. Do not perform cuts
in poor light conditions, like in the dark, at night, at dusk, at dawn or with dust or sand in the air impeding clear
visibility below 2 metres. The areas in which the machine is used must have adequate lighting of 100 lux with
a minimum uniformity of 0.7 over the work area and 50 lux, with uniformity of at least 0.3, in the immediate
vicinity.
- Do not use the tool in hazardous conditions for the operator, on slippery ground and/or on steep slopes.
- Always ensure correct posture (legs slightly apart with one foot in front of the other for greater force of action,
upright torso) respecting rest periods on use (one rest period per hour of work is suggested), on changeover
and position during work.
- Make sure not to get the product wet, immersed or in contact with water, snow, damp surfaces in general in
order to avoid damaging it.
0310.0436_00 94