CAMPAGNOLA POWER ECO PLUG-IN Manuel D'utilisation Et D'entretien page 101

•
Lubrication of the connecting links: unscrew the cap (A) then, using a greaser, lubricate using lithium soap
+ PTFE grease.
•
Lubrication of the connecting rod: unscrew the cap (B) then, using a greaser, introduce lithium soap + PTFE
grease into the connecting rod hole.
•
Operate the tool with no load for a few seconds and repeat the operation until the grease runs out.
(*) For the type of grease/lubricant and/or adhesive/sealant recommended, see paragraph 7.3.3.
7.1.5 PRODUCT CLEANING
This paragraph contains the information and instructions to be observed when cleaning the power unit and the
harvesting head.
Periodically check the integrity of the fixed guards and their fixings, paying particular attention to the access
guards to the product mechanics.
Keep the power unit and harvesting head clean using a cloth or brush.
Do not spray or immerse in water.
Do not use cleaning agents that could permanently damage them.
Pay particular attention to the cleanliness of the slits on the power unit, which have the function of circulating air
inside the power unit for motor cooling.
7.1.6 END OF WORK MAINTENANCE
After use, or in the case of long periods of inactivity, it is prescribed to:
•
Follow the procedure for switching off and securing the product as described in paragraph 6.5.
0310.0436_00
ELEKTRA harvesting head
101