CAMPAGNOLA POWER ECO PLUG-IN Manuel D'utilisation Et D'entretien page 106

Supplier
Type
Use
NOTE: The above-mentioned grease must be used for all maintenance activities relating to the greasing of
connecting links.
PAKELO MOTOR OIL S.r.l.
Supplier
PAKELO MULTIPLEX EP GREASE NLGI 2
Type
Suitable when exceptional load and wear resistance is required in a variety of applications.
Use
NOTE: The grease specified above must be used for all maintenance activities relating to the greasing of gears
and mechanical parts in all disassembly/assembly and/or adjustment activities covered by the maintenance
activity.
Characteristics of the adhesive/sealant used
The sealant data sheets in this section only contain the main technical characteristics required for purchase, but
not the safety information related to its use.
Before use, request the 'product safety data sheet' from the manufacturer, which can also normally be found on
the supplier's website.
The manufacturer prescribes the use of LOCTITE adhesive/sealant. The adhesive enables maintenance
personnel to prevent persistent equipment failures that cause unscheduled downtime. For further technical details
see the Loctite data sheet available on the supplier's website.
The manufacturer prescribes the use of '
seal screws and/or bolts to prevent loosening due to vibration.
Excellent on any metal, including passive materials (e.g. stainless steel, aluminium, galvanised surfaces). It can
be disassembled by heating up to 300°C.
The manufacturer prescribes the use of "
locking and/or sealing of threaded fasteners requiring normal disassembly with standard hand tools.
Excellent on any metal, including passive materials (e.g. stainless steel, aluminium, galvanised surfaces). It can
be disassembled by heating up to 250°C.
8. TROUBLESHOOTING
Troubleshooting can only be carried out by trained personnel who have understood the instructions in this manual
and the accompanying documentation.
Situations that can lead to a failure are normally attributable to a lack of or poor maintenance or a failure of some
mechanical and/or electrical/electronic component of the product or a situation related to the material being
handled.
The following table lists possible faults that can occur on the tool. The "Cause" column shows the cause of the fault
condition.
The "Solution" column shows the corrective action to resolve the fault situation that has occurred.
FAULT
The tool does not work
The tool does not have
adequate power
0310.0436_00
Grease commercial data
PAKELO MOTOR OIL S.r.l.
LIPO HEAVY GREASE 2
Lubricator grease
Grease commercial data
LOCTITE® 270™
LOCTITE® 243™
CAUSE
ON/OFF switch in OFF position.
Low battery
Battery cable connector not plugged in
Damaged connector
Low battery level
': high-strength threadlocker formulated to lock and
": a medium-strength threadlocker designed for the
Move the switch to the ON position.
Recharge the battery
Insert the connector
Contact a T.A.C.
Recharge the battery
106
SOLUTION