Ernesto 428593 Conseils D'utilisation Et D'entretien page 107

C LE A N P R OD U CT C LE A N P R OD U CT
Clean the pressure control valve:
After each use, remove the pressure control valve by turning part „7a" counterclockwise until the
„ " sign and the „ " sign are at the same level (Fig. 8). You can then remove the pressure con-
trol valve. Make sure that the spring remains in the valve. Carefully rinse all parts in water and
reassemble. Rotate part „7a" to confirm that it rotates smoothly and to the right.
If this is not the case, the spring is not inserted correctly.
Clean the pressure control valve base (part 8) and the pressure relief tube (part 3):
After each use, check that the pressure relief parts are clean. The pressure relief parts can be
cleaned in warm water (Fig. 8). Remove the valve and valve base and confirm if the valve seal
is clean and free of wear. Replace the sealing ring if it is worn or cracked. Rinse all parts in
warm water. Assemble all parts as originally.
S AF E T Y VA LVE S AF E T Y VA LVE
After each use, check that the safety valve is clean. Rinse it in warm water.
If necessary, you can move (push in) the valve slightly with the back of a
needle to loosen stuck dirt (Fig. 17).
S EA LI N G R I N G S EA LI N G R I N G
Rinse in warm water or with a little soapy water after each use.
Insert the sealing ring correctly into the recess provided for it in the safety valve.
N O T I C E : WA R NING! REPAIRS MAY O NLY B E CA RRI E D OUT BY AUT H OR I ZE D N O T I C E : WA R NING! REPAIRS MAY O NLY B E CA RRI E D OUT BY AUT H OR I ZE D
P E R SON N EL . P E R SON N EL .
PR OB LE M PR OB LE M
No pressure builds up
in the appliance.
IAN 428593_2301
T R OU B L ES H O O TI NG T R OU B L ES H O O TI NG
POS SIBLE CAU SE POS SIBLE CAU SE
The pressure indicator
does not rise.
Too small quantities of co-
oking liquid
The upper and lower hand-
les are not joined properly
and the sealing ring is not in
the correct position.
The sealing ring is not clean. Clean the sealing ring.
R E ME D Y R E ME D Y
Use a higher temperature
setting.
Add more cooking liquid.
Close the pressure cooker
until it has cooled down.
Join the two handles properly
and put the sealing ring in
the right position.
107 |
koÜDq
fig. 17