Ambu aScope 5 Broncho HD 5.0/2.2 Mode D'emploi page 9

No. Part
6 Suction button
7 Endoscope buttons
1 & 2
8 Rotation control ring
9 Tube connection
Insertion cord
10
Insertion portion
11 Bending section
12 Distal tip
13 Displaying unit
connector
14 Cable
15 Protective
handle cover
16 Protective pipe
17 Introducer
3. Use of aScope 5 Broncho HD
Numbers in gray circles below refer to illustrations on page 2.
3.1. Preparation and inspection of aScope 5 Broncho HD
Lubricate the insertion cord with a water based medical grade lubricant, to ensure the lowest
possible friction when the endoscope is inserted into the patient.
Visual inspection of the endoscope 1
1. Check that the pouch seal is intact. 1a
2. Make sure to remove the protective elements from the handle and from
the insertion cord. 1b
3. Check that there are no impurities or damage on the product such as rough surfaces,
sharp edges or protrusions which may harm the patient. 1c
4. Turn on the Ambu displaying unit. 2a 2b
Refer to the Ambu displaying unit Instructions for use for preparation and inspection of
the Ambu displaying unit. 2a 2b
Inspection of the image
1. Plug in the displaying unit connector into the corresponding connector on the
compatible displaying unit. Please ensure the colors are identical and be careful to
align the arrows. 3a 3b
2. Verify that a live video image appears on the screen by pointing the distal tip of
the endoscope towards an object, e.g. the palm of your hand. 4
3. Adjust the image preferences on the displaying unit if necessary (please refer to
the displaying unit Instructions for use).
4. If the object cannot be seen clearly, wipe the lens at the distal tip with a sterile cloth.
Function
Activates suction when pressed.
Depending on settings in displaying unit the two remote
switches allow for direct activation on handle of four
different functionalities such as image and video
capturing, ARC, zoom.
Allows for rotation of the insertion cord during procedure.
Allows for fixation of tubes with standard connector
during procedure.
Flexible airway insertion cord.
Same as insertion cord.
Maneuverable part.
Contains the camera, light source (two LEDs),
as well as the working channel exit.
Connects to the connector port on the Ambu
displaying unit.
Transmits the image signal to the Ambu displaying unit.
Protects the control lever during transport
and storage. Remove before use.
Protects the insertion cord during transport
and storage. Remove before use.
To facilitate introduction of Luer Lock syringes.
9