Publicité
Les langues disponibles
Les langues disponibles
2 - Installation of the oven
EN
To install the oven into the kitchen a cutout should be made in
accordance with the dimensions shown in Fig. 1.
The apparatus is to be fastened to the top by means of the two
screws provided in the kit through the holes made on the oven
uprights.
The cabinet in which the apparatus is installed shall be open
on the back side to ensure a sufficient air circulation and
prevent overheating.
Leave a gap of at least 200 cm
if the oven is installed in a column; this is not necessary if the
oven is installed under the work top.
WARNING
As the apparatus is to be fitted in your kitchen
furniture, make sure that all surfaces in contact
with the oven can resist a temperature of approx
90°C.
Electricals
Absorbed power:
oven top element:
oven bottom element:
round element (hot air):
roasting jack motor:
lamp:
hot air fan motor:
cooling fan motor:
Maximum absorbed power:
(see data plate)
Supply voltage:
(see data plate)
NOTE:
This appliance is in compliance with following European
directives: 2006/95/CE (LVD), 2004/108/CE (EMC),
2011/65/CE (RoHS), 2012/19/UE (WEEE), 2002/40/CE.
4
(see Fig. 1) for air circulation
2
1200+1000W 230V -
1200+1000W 240V
1100W 230V - 1100W 240V
2300W 230V - 2300W 240V
(on some models)
4 W
(on some models)
25 W
25 W
25 W
Respect for the Environment
The documentation for this appliance is printed on paper bleached
without chlorine or recycled paper to contribute to protecting the
environment.
The packaging was designed to prevent damage to the environment;
they are ecological products that can be recovered or recycled.
Recycling the packing saves raw materials and reduces the volume of
industrial and domestic waste.
THE PACKING MATERIAL is 100% recyclable and marked with the
recycling symbol.
Dispose of in conformity with local law. The packing material (plastic
bags, polystyrene parts, etc.) must be kept out of the reach of children
because it is potentially dangerous.
THIS APPLIANCE is marked in conformity with European Directive
2002/96/EC, Waste Electrical and Electronic Equipment (WEEE).
By making sure that this product is disposed of correctly, the user
contributes to preventing potential negative consequences for the
environment and health.
THE SYMBOL on the product or accompanying documentation
indicates that this product must not be treated as domestic waste but
must be delivered to a suitable collection point for the recycling of
electrical and electronic equipment.
DISPOSAL MUST BE MADE in conformity with local laws on waste
disposal.
FOR ADDITIONAL INFORMATION about the treatment, recovery and
recycling of this product, contact the local office of competence, the
domestic waste collection service or the store where the product was
purchased.
BEFORE SCRAPPING, make it unusable by cutting the electrical cord.
Publicité
