Pommier A5441 Mode D'emploi page 39

7. PRE-COMMISSIONING CHECK
1. Perform the underrun bar tests in the low and high position
2. In the high position, check the locking of the underrun bar by pushing or pulling the bar
3. Check regulatory dimension compliance when the bar is in the low position (road) (figure1, 2 and 3 dimensions P, G
and 0 to 100mm in relation to the tyre flanks)
8. USING THE PRODUCT AND RECOMMENDATIONS FOR USE
OPERATION OF THE LOCKING HANDLE
Manual release
RECOMMENDED USE IN ACCORDANCE WITH THE FOLLOWING LABEL (SUPPLIED)
1. Inform and train end users in use of the bar and the associated risks.
2. Explain to users that a safety zone must be established when manoeuvring the underrun bar.
3. Explain to users that the underrun bar is manoeuvred when the vehicle is stationary.
The label must be visibly displayed on the arm after painting.
Arm movement Automatic locking
39/143