Pommier A5441 Mode D'emploi page 37

13.
Unlock the arms to return them to their low positions.
14.
There are 3 options for fitting the tube:
14.1 - Fitting using clamps (No. 15)
Washers (No. 16) and M14 lock nuts (No. 17), position the tube (No. 14) to check compliance with
dimensions G, P, E and max. 100 in accordance with figures 1, 2 and 3.
(No. 17) to the torque specified in table 1.
Distortion of the arms, level with the brackets holding the clamp, may be visible after tightening the
clamps.
Check that placing the underrun bar in its high position does not interfere with the chassis and its
accessories.
If necessary, adjust the chassis side rails.
(16), (17)
Fitting using screw clamp,
(15)
(14)
Figure 26
Tighten the M14 CL8 nuts
37/143