Pommier A5441 Mode D'emploi page 29

5a. MOUNTING 1: DRILLED LOW PLATE ON AN UN-DRILLED SIDE RAIL
All the holes must be used (figure 9).
We recommend using the plates as a drilling template.
8 x Ø15 holes and 2 x Ø26 holes** must be created in each side rail.
You must use 2 rows of 4 x M14 class 10.9 screws on each side rail. The 2 following installation diagrams can
be used.
The use of M16 class 10.9 screws is possible on condition that the washer + screw head height does not
exceed 12 mm and the Ø does not exceed 26 mm. In this case, you must back-drill the plates at 17 mm.
Front of the vehicle
Or
Front of the vehicle
* See the manufacturer's bodywork fitting instructions for the vehicle to be equipped.
** It is possible to avoid creating the 2 x Ø26 holes in each side rail. See figure 15
(**)
(**)
Drilling to be performed on the side rail,
min.*
Rear of the vehicle
min.*
min.*
Rear of the vehicle
min.*
Figure 9
29/143