Pommier A5441 Mode D'emploi page 31

5.c INSTALLATION OPTION 3: UNDRILLED HIGH PLATE ON A DRILLED OR UNDRILLED CHASSIS SIDE RAIL
You must use at least 14 x M14 class 10.9 screws to attach the plates to each side rail.
13 x Ø15 holes must be created per plate. The existing hole must be used.
The use of M16mm screws is possible on condition that the washer + screw head height does not exceed
12 mm and the Ø does not exceed 26 mm. In this case, you must back-drill the plates at 17 mm.
FRONT OF
THE
VEHICLE
Pitch (x) in mm
45, 50, 55 or 60 mm
* See the manufacturer's bodywork fitting instructions for the vehicle to be equipped.
5d. MOUNTING 4: UN-DRILLED LOW PLATE ON A DRILLED OR UN-DRILLED CHASSIS SIDE RAIL
You must use 2 rows of 4 x M14 class 10.9 screws on each side rail.
For the Ø26 holes, we recommend using the plates as a drilling template.
The use of M16mm screws is possible on condition that the washer + screw head height does not exceed
12 mm and the Ø does not exceed 26 mm. In this case, you must back-drill the plates at 17 mm.
Front of
the
vehicle
* See the manufacturer's bodywork fitting instructions for the vehicle to be equipped.
(**)In order to avoid the 2 x Ø26 drill holes per chassis side rail in the case of mountings 1 and 4.
2 spacers defined below can be created for insertion between the side rail and the low plate
min. 15
min. 15
min. 15
min.*
X (mm)
Minimum 200 mm
Drilling to be performed on side rails and plates,
(**)
Permitted installation diagram for the undrilled low plate,
+1
(x4) Ø15
0
(or Ø17 for M16)
REAR OF
THE
VEHICLE
min.*
min. 15
min.*
min.*
min. 15
Reference hole
Y (mm) Z (mm)
40-60mm 150-180mm
Figure 13
min. 15
MAX. 27.5
min. 18
Figure 14
The thickness of the spacer must be
included in the mounting frame width for
plates (see fig. 2).
min. 8
Figure 15
Rear of
the
vehicle
min. 18
31/143