Pommier A5441 Mode D'emploi page 36

9.
Pre-tighten the brackets (No. 7) on the arms (Nos. 3 and 4) using an M8 screw (No. 8), a washer (No. 9)
on the nut side (No. 13) without locking them to permit rotation.
(3), (4)
(7)
(8)
10.
At the end of the bracket, tighten the screw (No. 8) with the washer (No. 9) on the thin nut side (No.
11).
11.
Mount the spacer (No. 21) on the screw and then mount the gas spring (No. 12) on the 2 screws by
rotating the bracket on the arm.
Tighten the M8 Nylstop nuts (No. 13) without locking gas spring rotation.
Do not restrict the gas springs by tightening the nuts too tightly.
(12)
(21)
12.
Use a wrench or spanner type tool to rotate the bracket in order fit the 2
Fit the washers (No. 9) on the nuts side (No. 13) then tighten them to the torque specified in table 1.
(9), (13)
(9), (13)
Figure 20
Figure 22
Figure 23
Figure 24
Figure 25
Figure 21
(9), (11)
(8)
nd
mounting screw (No. 8).
(8)
(13)
36/143