Télécharger Imprimer la page

Fagor TWIRLOCK Serie Manuel De L'utilisateur page 27

Publicité

Les langues disponibles

Les langues disponibles

PROBLEM
The visual pressure indicator has popped up, but there is no steam relea-
sed by the operating valve.
REASON
1. There is not enough liquid in the cooker.
2. The valve is dirty and/or obstructed.
3. The burner heat is not high enough.
SOLUTION
1. Make sure there is enough liquid. There should always be at least half
2. The valve can become dirty when cooking foods such as dried beans
3. Turn up the heat to medium high until a gentle, steady stream of steam
PROBLEM
A gentle, steady stream of steam is released from the operating valve and
small drops of water condensation collect on the lid.
REASON
When used properly, the operating valve will release a gentle steady
stream of steam as well as some drops of condensed water on the lid.
SOLUTION
This is normal operation. If there is a lot of water gushing out of the ope-
rating valve with the steam, see below.
PROBLEM
A strong, forceful, gushing jet of steam is escaping from the operating
valve with or without drops of condensation.
REASON
1. The burner heat is too high.
2. The valve is dirty.
3. The safety valve is malfunctioning.
SOLUTION
1. Lower the heat so that only a gentle, steady stream of steam is
2. Check the valve to see if there are any remaining food particles.
3. The
PROBLEM
Steam is escaping around the edge of the lid.
REASON
1. The pressure cooker is too full.
2. The pressure cooker was not closed properly.
3. The silicone gasket is not in place, or it is dirty or worn.
SOLUTION
1. Never fill the pressure cooker more than MAX 2/3 line or ½ full when
2. Following the instructions given in this manual, close the pressure
3. Make sure the silicone gasket is clean and well positioned before
Twirlock Manual.Interior.FINAL.indd 27
Twirlock Manual.Interior.FINAL.indd 27
All manuals and user guides at all-guides.com
a cup of liquid in the pressure cooker, or 2 cups if the cooking time is
over 10 minutes.
which have a tendency to foam. Clean the valve periodically. See the
"Care and Cleaning" section in this manual for instructions on how to
remove the valve for cleaning.
is released from the operating valve.
released.
Remove with a toothpick.
safety
valve
must
Customer Service Department at: 1-800-207-0806 or email at: info@
fagoramerica.com.
cooking liquids or foods that froth and expand during cooking.
cooker so that a tight seal is created which will allow for adequate
pressure build-up.
using the pressure cooker. After continued use, the silicone gasket
will begin to wear and should be replaced at least once a year if the
pressure cooker is used frequently.
be
replaced.
Contact
the
Fagor
27
6/2/16 8:34 PM
6/2/16 8:34 PM

Publicité

loading