Publicité
Les langues disponibles
Les langues disponibles
18 Ionizer
18.1 General hints
The ionizer is available for the ABP-series as Factory Option. In the ABP-A series it is
installed as per standard.
The ionizer has conductive peaks supplied by high voltage which, based on corona
discharge, generate positively and negatively charged ions in the immediate vicinity.
These are attracted by the electrostatic charge of goods to be weighed and, thus,
neutralize the interfering electrostatic charge. This also does away with the forces
falsifying the weighing (such as falsified weighing result, weighing value drifted).
18.2 Basic Safety Precautions
The use of ionizer is only intended in combination with electronic
weighing balances. Do not use for any other purposes.
Never operate the ionizer in explosive environment. The serial version is
not explosion protected.
Protect the ionizer against high air humidity / temperature, steams and
dust;
Take care to select a location free of water and oil
Do not expose the ionizer to strong humidity for extended periods. Non-
permitted condensation (condensation of air humidity on the appliance)
may occur if a cold appliance is taken to a considerably warmer
environment. In this case, acclimatize the disconnected ionizer for ca. 2
hours at room temperature.
Whilst the ionizer is switched on, do not touch the ion source; see sticker
on the left side.
In case of smoke development, smell of fire, strong heating-up of the
ionizer or when the red LED starts glowing, turn off the ionizer
immediately and disconnect it from the mains.
If water or other foreign matter enters the ionizer, turn off the master
switch immediately and disconnect it from the mains.
On account of the high voltage technology, handle the ion source and
exits with care.
Do not dismantle or modify the ionizer.
145
WARNING
TABP-BA-e-2212
Publicité
