Publicité
Les langues disponibles
Les langues disponibles
7.3.2 Assembly of the internal windshield
(only ABP-A Semi-Micro models)
Open the glass door completely
(top)
Take hold of the handle of the
adjustable windshield pane with
your preferred hand. Insert the
adjustable windshield pane slowly
and carefully from the upper
opening in order to avoid that the
glass door is touched.
Insert the upper pins into the
grooves, while keeping up the
adjustable windshield plate in order
to ensure that it is in horizontal
position.
The internal windshield cannot be
locked in any position in the middle
of the guide rail. Make absolutely
sure that the lever engages after
releasing.
7.3.3 Connection of the ionizer
see chap. 18.
Semi-Micro models
27
Introduce the pin in the lower middle
of the internal windshield from front
into the groove in the center of the
guide rail.
The internal windshield can be moved
upwards and downwards by holding
fast the handle and pulling the lever.
Release the lever, the internal
windshield is locked, when the handle
is released.
Adjust the position and use the internal windshield according to the
samples/containers in a manner that it does not cause an obstacle.
Plug the connected ionizer-AC
adapter and the net cable into the
DC IN-connection (for the ionizer).
Connect the power plug of the
ionizer to a plug-in socket.
Connect the connections of the
ionizer (2 connections) on the
backside of the ionizer with the
ionizer connecting cable.
Attach the adapter cable holders on
the backside of the main housing to
the positions shown in the figure.
Remove the backing paper from the
holder, to uncover the adhesive
surface, and press then the
adhesive surface on the main
housing in the alignment shown in
the figure.
Introduce the lower pins (on
both sides) into the guide
rail.
Adjust the internal windshield in a
way that the upper side of the
internal windshield remains on the
same level as the slideway.
Excepted Semi-Micro models
TABP-BA-e-2212
Publicité
