Publicité
Les langues disponibles
Les langues disponibles
Set output condition:
Use the navigation keys <Settings data
output> and confirm using the OK-key.
Use the navigation keys to select the desired
setting and confirm using the OK-key.
Stable/positive value
Stable/negative value
Stable at zero
Pass/ Fail
Set zero value limit
Return to weighing mode
Press the ON/OFF button.
From here on the Auto Print function is active,
the indicator
Place goods to be weighed on balance
If required, place empty container on scale and tare.
Place weighed goods and wait until the stability display ( ) appears. The
weighing value is issued automatically.
Remove the weighed good.
15.8.2
Continuous data output
The
TABP-BA-e-2212
Single output for stable and positive weighing value.
Single output for stable and positive or negative weighing value.
Single output for stable and positive weighing value. New output only
after zero display and stabilization
If the Auto Print function is connected to the check weighing function,
data of stable weighing values are output with indicator display
[Zero]
[50 % of
previous
output]
is displayed.
icon will be displayed while the function is enabled.
Not combinable with automatic data output.
Another output when the display goes back to zero. Setting
for priority of accuracy
Another output when the display goes back to 50% of the
previous weighing value.
Setting for priority of work efficiency
.
.
132
Publicité
