Publicité
Les langues disponibles
Les langues disponibles
7.3 Placing
7.3.1 Installing the glass windshield doors (only ABP-A series)
Make sure that the stopper knobs are attached to the glass doors (top,
left, right) before switching-on the device.
Otherwise the glass doors could be damaged.
Installation of the glass windshield door (top)
Insert the handle of the glass door (top)
from the front side of the upper part and
fasten the stopper knob from inside of
the weighing space in a way that it is in
a parallel position to the handle as
shown in the figure on the right.
If the stopping section of the stopper knob protrudes
farther than the handle, the door cannot be completely
closed; so install it in a manner that it is in a parallel
position to the handle.
Installation of the glass windshield door (right)
Keep the handle of the glass door (right)
with the right hand and the upper edge
with the left hand and insert the lower
edge of the glass door into the right rail
of the balance, as shown in the figure on
the right.
Align the rail to the upper groove of the
housing and lift your left hand a little bit
in order to bring the glass door into a
horizontal position, then slowly insert the
glass door. Close the glass door halfway
and attach the stopper knob from the
inside of the weighing space, so that is
in a parallel position to the handle.
If the stopping section of the stopper knob protrudes
farther than the handle, the door cannot be
completely closed; so install it in a manner that it is in
a parallel position to the handle. See for this the figure
on the right.
Ensure that you don't touch the toothed rack of the
glass door, the motor driving wheel etc. and that no
dirt or foreign body gets in the transmission gear.
Otherwise damages may occur.
Installation of the glass windshield door (left)
Fasten this door in the same way like the right-hand glass door.
TABP-BA-e-2212
Gear box
Stopper knob
26
Publicité
