Publicité
Les langues disponibles
Les langues disponibles
13.10.1
Switch-over the operating mode of the IR sensors
The ABP-A series has a multifunctional mode, in which four functions maximum can
be assigned to the IR sensors. The operating modes of the IR sensors vary
depending on whether this mode is turned on or turned off.
The multifunction mode is enabled as per standard.
IR sensor operation with enabled multifunction mode
When the multifunction mode is enabled, four functions maximum can be assigned to
the IR sensors.
In the following you will see function examples of the IR sensors.
- Actuating the doors by running the hand over the left/right sensor
- Edit data by holding the hand above the IR sensor for approx. 2 seconds after
having placed the sample and the weight value having been stabilized
By that way you can carry out a lot of procedures such as opening and closing the
doors, taring and editing the weighing value without pressing any button of the
operating field.
LED
In figure 1 & 3 you run your hand or your fingers over the IR sensor
The LED lights up
Then remove the hand or the fingers
The LED switches off and the function is enabled.
81
Actuate right IR sensor (short)
Run the hand over the sensor and
remove it (when the LED lights up)
Actuate right IR sensor (long)
Hold the hand above the sensor, that the
LED will light up for approx. 2 seconds.
Actuate left IR sensor (short)
Run the hand over the sensor and
remove it (when the LED lights up)
Actuate left IR sensor (long)
Hold the hand over the sensor, that the
LED will light up for approx. 2 seconds.
TABP-BA-e-2212
Publicité
