Publicité
Les langues disponibles
Les langues disponibles
13.10 Configuration methods of the IR sensors (only ABP-A series)
In this section we explain how you can switch-over the operating modes for the IR
sensors and how you can assign functions to every IR sensor. After having
configured the operating modes of the IR sensor, assign functions to the configured
operating modes. The functions which can be assigned to the IR sensors, are listed
in the following table.
If you don't use the IR sensors
You can configure the IR sensors in a manner that they are not enabled, even if you
run a hand over the sensors. For this purpose don't assign any button function to the
IR sensors.
Button
The button to open and to close the door (left) can only be assigned to the left
IR sensor while the button to open and to close the door (right) left can only
be assigned to the right IR sensor. The settings of the IR sensor are not reset,
even if the current supply is switched off and on again. The settings of the
position memory function, however, are reset.
TABP-BA-e-2212
Designation
Buttons for
Opening and closing glass doors which have been
opening and
configured by the position memory function.
closing doors
Data output to external device (weighing mode)
[PRINT]
Taring
Zeroing
[TARE]
Starting the ionizer
(ABP series Factory option)
[Ionizer]
Function
80
Publicité
