Securing The Support Bar; Mounting The Support Panels; Mounting The Bottom Chamber Assembly - Pit Boss PBV3A1 Mode D'emploi

3. SECURING THE SUPPORT BAR

Parts Required:
1 x Support Bar (#15)
4 x #10–24x½" Screw ( #C)
Installation:
• Install the Support Bar to the rear of the unit between the two rear
Support Legs. Secure using two screws on each side. Ensure the Support
Bar is place on the underside of the main cabinet, facing inwards. Note
illustration for Support Bar arrangement.

4. MOUNTING THE SUPPORT PANELS

Parts Required:
Support Panel (#16)
2 x
8 x #10–24x½" Screw ( #C)
Installation:
• Install one Support Panel to the side of the unit between a front and
back support legs. Secure using two screws on each side. Ensure the
flat side of the Support Panel is facing outwards. Repeat the same
installation to mount the other support panel. Note illustration for
Support Panel arrangement.
NOTE: The Support Panel with two holes along the bottom should
be on the same side of the unit as the power cord exits the Control
Panel (left side). This is important for later steps.

5. MOUNTING THE BOTTOM CHAMBER ASSEMBLY

Parts Required:
1 x Bottom Chamber Assembly (#20)
4 x #10–24x½" Screw (#C)
Installation:
• Mount the Bottom Chamber assembly to the bottom of the cabinet
base using four screws. Ensure the rails for the grease tray are facing
the front of the unit. Note illustration for proper positioning.
8
3
15
4
16
5
16
20
FRONT