Ducati MH900 evoluzione Manuel De L'utilisateur page 110

Stop light (fig. 47)
To replace the stop and parking light bulb, unscrew the
two screws (3) that secure the glass (4). Remove the
glass. The bulb is of the bayonet-type: press and rotate
anti-clockwise to remove. Fit the spare bulb by pressing
and turning clockwise until it clicks. Refit the glass.
Number plate light (fig. 47)
To expose the number plate bulb, unscrew the screw (5)
and the two screws (6) located on the light bottom.
E
Withdraw the lamp holder, extract the bulb and replace it.
To reassemble, reverse the disassembly procedure.
Rear turn indicators (fig. 47)
Remove the screw (1) and detach the glass (2) from the
body. The bulb is of the bayonet-type: press and rotate
anti-clockwise to remove. Fit the spare bulb by pressing
and turning clockwise until it clicks. Refit the glass sliding
the small tab (A) into the suitable slot in the indicator
body.
Tighten the screw (1).
Front turn indicators (fig. 48)
Remove the screw (3) and detach the glass (4) from the
body. The bulb is of the bayonet-type: press and rotate
anti-clockwise to remove. Fit the spare bulb by pressing
and turning clockwise until it clicks. Refit the glass and
tighten the screw (3).
44
3
1 2
A
3
4
6
4
2
A 1
5
fig. 47
fig. 48