Rizzoli S Série Manuel D'utilisation page 92

NO
Picture 10 - Examples of correct and incorrect connection of the chimney.
2.10 FLUE OUTLET ON THE SIDE (OPTIONAL)
If the chimney is on the side in correspondence of
a side, it is possible to order the flue outlet on the
side. Also in this case, the connector is extractable.
To install it correctly, it is necessary to remove
the cooking plate. Now, the connector must be
completely inserted inside the wood fired cooker/
thermal cooker or the chimney, keeping the fixing
Picture 11 - Flue outlet on the side. Fixed connector for the flue outlet on the side.
2.11 ADJUSTABLE REAR FLUE OUTLET (S 60)
On most models without oven it is possible to
change the position of the rear flue outlet. The
movement can be done both horizontally and ver­
tically, in order to connect more easily the pipe to
the chimney hood. For the horizontal regulation,
it is necessary to unscrew the 8 screws sustain­
ing the external sheet and then screw again them
when the flue outlet is in the chosen position. On
some models, it is possible to obtain further regu­
lations removing and tilting the sheet (see picture
12b). On demand, Rizzoli can provide an extra
NO NO
buttonhole on the same side of the cooker. Then,
you can place the wood fired cooker, extract cor­
rectly the connector so that it connect the cooker
with the chimney. Finally, bend the buttonhole
and block the parts with the screw­lock (see pic­
ture 11).
sheet to be used in the intermediate positions of
the sheet. For both the horizontal and the vertical
regulations there is a tolerance of 1 cm thanks to
the provided bayonet fitting as described in para­
graph 2.9.
In the following tables are reported, for each mod­
el with oven, the minimum and maximum dimen­
sions (in mm) of the distances from the centre of
the hole of the rear flue outlet from the external
side of the frame.
90
YES