Maintenance - Rizzoli S Série Manuel D'utilisation

5

MAINTENANCE

5.1 CLEANING
The device works better if all its parts are without
combustion residuals, a clean device will be less
exposed to problems due to wear. Cleaning fre­
WARNING! All these operations must be done with cold cooker or thermal cooker.
5.2 CLEANING THE VISIBLE PARTS
Stainless steel parts have to be cleaned cold with
neutral detersives or with a specific solution for
stainless steel in case of hard to remove dirt. Do
not use at all abrasive sponges that may scratch
the surface. Dry with a soft rag, following the glaz­
ing wise.
In particular situations, after the installation or
with the cooking of meals, an oxidised superfi­
cial stratus may be generated, in particular on the
inox stainless steel frame. Also in these situations,
5.3 MAINTENANCE OF THE COMBUSTION CHAMBER SHEETS (ST 90)
Inside the combustion chamber of the wood fired
thermal cooker are placed some mobile steel
Picture 40 – Maintenance of the combustion chamber sheets.
quency depends on how much and how the device
is used, as well as combustible quality.
an accurate cleaning will restore the state of the
product as it was new.
On request Rizzoli gives specific products to clean
stainless steel. For enamelled or painted parts, do
not use abrasive or aggressive solution and in case
of stains pour some oil and wait while it absorbs
the halo, then clean with a soft rag. It is also rec­
ommended to avoid the use of solvents or dena­
tured alcohol on painted parts.
sheets that have a double function: they allow the
entrance of the secondary air after­combustion at
1
110
2
1