Chimney Pot - Rizzoli S Série Manuel D'utilisation

2.6

CHIMNEY POT

The chimney pot must have an exit section dou­
bled than the one of the chimney, in order to make
easier the exit of the smoke. The chimney pot must
be enough tall to lean out over the reflow zone
2.7 CONJUNCTION OR FUME CONDUCT
The conjunction of the device to the flue must be
as short as possible and must not have horizontal
or not much inclined parts. The counterslope parts
are forbidden and must be absolutely avoided.
Near the conjunction, inflammable materials must
not be present. The conjunction must not go inside
2.8 FLUE OUTLET PREDISPOSITION
Wood fired cookers and thermal cookers are pre­
disposed to have flue outlets in different positions
(up, back, sides).
Before connecting the device to the chimney you
S SERIES WITHOUT OVEN
Picture 7 - Multiflue cooker without oven, predisposition of the correct flue outlet
generated by the roof: if you are not sure about
this contact experienced technicians. If you are
in a windy place, it might be necessary to install
windproof devices.
the flue. To increase the safety of the conjunction,
we suggest to install a washer on the wall being
sure that the connection between the washer and
the chimney is walled and well sealed. Also the
connection between the device and the conjunc­
tion must be fixed and sealed.
must be sure that all the outlets you will not use
are well closed. Eventually, you can make modifi­
cations using the devices given together with the
device.
88