Columbus McKinnon Yale C 85 750 Traduction De Mode D'emploi page 26

26
When replacing the chain, make sure that the chain is reeved correctly. The chain weld must
face outwards.
3/4 t 1,5 t - 3 t 6 t 10 t
Only fit load chains which have been approved by the manufacturer. Non-compliance with this
specification will render the legal warranty or guarantee void with immediate effect.
Function check
Before start-up, check that the chain drive is working in the unloaded condition.
O
PERATION
Installation, service, operation
Operators delegated to install, service or independently operate the hoist must have had
suitable training and be competent. Operators are to be specifically nominated by the
company and must be familiar with all relevant safety regulations of the country of use.
Releasing the chain
Turn pawl rod lever to neutral (central) position. The chain can now be pulled in both directions
and the load chain fall will be quickly tensioned.
Attention: The minimum load to engage the automatic brake lies between 30 and 45 kg.
Lifting the load
Turn pawl rod lever to the lifting position "↑" and lock it.
Operate hand lever with a pumping action. If work is stopped while the hoist is under load, the
pawl rod lever must remain in the lifting position "↑".
Lowering the load
Turn pawl rod lever to the lowering position "↓" and lock it.
Operate hand lever with a pumping action.
Brake jamming
lf a hoist, which is under load, is suddenly relieved of load pressure, e.g. by lifting off the load
or when pulling down walls, and lowering has not been initiated first, the brake will remain
locked. The brake will also lock if the load hook with the bottom block is pulled too tightly
against the housing.
©
2016 Columbus McKinnon Industrial Products GmbH