Mounting The Oven Door; Cleaning The Glass Panels Of The Oven Door - Franke Crystal CR 982 M Manuel D'utilisation

Mounting the oven door

After cleaning, the oven door has to be mounted again.
Slide the hinges into their grooves.
X X
Turn the two block hooks (used as hinge attachments)
X X
upwards.
CAUTION! Damage to the oven due to wrong
handling!
Never try closing the door when one or both blocks
Z X
are partially or completely open.
Close the oven door.
X X

Cleaning the glass panels of the oven door

The oven door and the glass panels can be removed to
enable thorough cleaning of the glass panel.
The oven door has 3 glass panels:
– internal glass panel (near the cavity)
– intermediate glass panel (inside the oven door)
– external glass panel
The internal glass panel and the intermediate glass panel
can be removed for cleaning purposes.
The inside of the external glass panel can be cleaned when
the internal and the intermediate glass panel are removed.
Removing and cleaning the internal glass panel
from the oven door
Ensure that the oven is cold before you start cleaning.
Z X
Open the oven door
X X
completely.
Turn the two black blocks (with the word CLEAN, at
X X
the bottom of the door) for 180° so that they fit into
the seats in the oven structure.
– Make sure to turn the black blocks completely.
The blocks click into their position.
„ „
CR 982 M
CAUTION! Damage to the oven due to wrong
handling!
If the blocks are not turned completely, removing the
glass panel will cause the oven door to close immediately.
Never try closing the door when one or both blocks
Z X
have partially or completely freed the glass panel.
Carefully push the
X X
internal glass panel
(1) towards the oven.
Then lift the internal
glass panel (2).
The two black
„ „
blocks will
prevent the door
from closing.
Clean the internal glass panel.
X X
Removing and cleaning the intermediate glass
panel of the oven door
After removing the internal glass panel, the intermediate
glass panel can be removed.
Carefully lift the intermediate glass panel out of the
X X
rubbers on both sides.
Clean the intermediate glass panel.
X X
Removing and cleaning the upper trims for
glass panels
For more thorough cleaning, the upper trims on the oven
door can be removed. The upper trims are fixed with
two screws, one in the upper right, one in the upper left
corner on the inside of the oven door. It is only possible,
to remove the upper trims when the internal glass is
removed.
Unscrew the fixing screws in the upper right and left
X X
corner of the oven door.
Remove the upper trim.
X X
Clean the upper trim.
X X
Mounting the glass panels
The correct position of the mounted glass panels is
indicated by the wording TEMPERED GLASS which must
be perfectly legible.
If unmounted, put the upper glass trim back in place.
X X
If unmounted, put the intermediate glass panel back in
X X
place within the rubbers.
Put the internal glass panel back in place.
X X
Turn the two glass retaining blocks back to their
X X
original position.
Close the oven door.
X X
– 29 –
2
1
EN