Cleaning The Side Frames And Telescopic Guides; Replacing The Oven Lamp - Franke Crystal CR 982 M Manuel D'utilisation

EN
Cleaning the side frames and telescopic
guides
To clean the side frames and telescopic guides thoroughly
they can be removed from the oven.
Removing the telescopic guides
2
1
A
2
B
3
Image A
With the telescopic guide in closed position press
X X
down firmly (1) to the middle of the wire rack where
the bottom side of the guide hooks.
Turn the guide in a anticlockwise direction (2) and
X X
remove it from the grid floor (3).
Image B
With the telescopic guide in open position, move
X X
forward the wire rack (1).
Turn the guide in a clockwise direction (2) and hook
X X
it on the bottom shelf (3) pressing towards of the two
hooks until you hear a click.
Removing the side frames
1
Bend the crosspiece which is engaged in the fixing
X X
bush downwards and remove it from the groove.
Push the side frame upwards and remove it from the
X X
two upper hooks.
Cleaning
Clean the side frames and the telescopic guides.
X X
After cleaning, keep the side frame tilted and insert the
X X
side frames into the two respective guides on the top.
Bend the crosspiece which is engaged in the fixing
X X
bush upwards and insert it in the groove.
Insert the telescopic guides.
X X
3
3
2
CR 982 M

Replacing the oven lamp

Franke ovens are equipped with two rectangular lamps.
3
The replacement lamp must meet the following technical
specifications:
– Temperature resistance: 300°C
– Voltage: 220-240 V, 50/60 Hz
– Power: 40 W
1
– Connection: G9
CAUTION! Damage to the lamp due to wrong
handling!
Avoid touching the lamps with bare hands.
Z X
Use a cloth or a sheet of kitchen paper.
Z X
WARNING! Possibility of electric shock!
Ensure that the oven is switched off before replacing
Z X
the lamp.
WARNING! Electric shock due to wrong
handling!
Switch the oven off.
Z X
– Depending on how the oven is installed: Unplug
the oven or disconnect the power at the main
electrical system switch, e.g., switch off the fuse of
the oven in the fuse box.
Remove the glass cover by carefully prying it off with a
X X
flat-blade screwdriver.
Remove the lamp from its holder.
X X
Replace the lamp.
X X
Reattach the glass cover.
X X
– 30 –