Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
„
„
Once a programme duration
is set, the end time cannot be
decreased. Likewise, the duration of
a programme cannot be prolonged
once the end time is set.
Programme run
„
„
When the automatic programme is in
progress (and therefore the cooking
function is active), the Auto symbol
remains lit and the remaining cooking
time appears on the display in
countdown form. The symbol
remains lit.
Automatic programme end
„
„
At the end of the programme duration
or when the end time is reached, the
corresponding symbol
„
„
At the end of the automatic
programme, the Auto symbol flashes,
the display shows "End" and an
intermittent acoustic signal (which can
be stopped by pressing any button)
sounds.
Timer function
The timer allows the setting of a time from
which a countdown begins. This function does
not turn the oven on or off, but only sounds an
audible alarm when the time has elapsed.
X
X
Press the Mode or Set button once;
the display shows:
„
„
The bell symbol flashes, then the
alarm duration can be set with the +
and – buttons. When this function is
active, the bell symbol remains lit and
the display shows the remaining time
(countdown).
„
„
At the end of the time an acoustic
signal (which can be stopped by
pressing any button) sounds.
Modifying/deleting data
X
X
The set data can be changed at any time by
pressing the + and - buttons together.
SGP 62 M _/F / SMP 62 M _/F / SMP 66 M _/F / CF 65 M _/F
goes off.
„
„
Cancelling the cooking duration
automatically ends the function, and
vice versa.
„
„
In case of programmed operation, the
appliance will not accept end of cooking
times prior to those of start of cooking
proposed by the appliance itself.
Note: The oven stays hot at around the set
cooking temperature for a long time after
it has been switched off; therefore to avoid
overcooking or burning the food, it is advisable
to remove it from the oven.
also
Switching on the first time
X
X
When using the oven for the first time,
operate it empty with the temperature knob
set to maximum for at least
40 minutes and airing the room.
„
„
The odour noticed during this
operation is due to the evaporation
of substances used to protect the
oven during the period between
manufacture and installation.
„
„
After the 40 minutes, the oven stops
automatically and will be ready for use
after cooling down the oven.
Suggestions
Z
X
For successful cooking, never place your
dishes in the oven when it is cold; wait until
it has reached the set temperature.
Z
X
During cooking, never place pots or
containers directly on the oven floor;
9 place them above the grills or drip-trays
provided, on one of the 5 shelves available;
„
„
failure to do so could damage the
oven enamel.
Z
X
Your Franke oven uses a special enamel
which is easy to keep clean, however it is
advisable to clean it frequently to avoid
baking on grime and previous cooking
residues.
Z
X
Any self-cleaning panels (if provided) can be
cleaned with soap and water (see cleaning
instructions).
– 12 –
Publicité
Chapitres
Table des Matières
