Placing And Securing The Oven; Electrical Connection; Control Panel - Franke SMART GN 42 ST XS Manuel D'installation Et Mode D'emploi

Placing and Securing the Oven
X Z
Place the oven into the cabin with two
or more people.
X Z
Ensure that oven's frame and front edge
of the furniture match uniformly.
X Z
Supply cord mustn't be under the oven,
squeeze in between oven and furniture
or bend.
X Z
Fix the oven to the furniture by using
the screws provided with the product.
Screws must be mounted as shown
in Figure 4 by passing them through
plastics attached to frame of the product.
X Z
Screws mustn't be overtightened.
„ „
Otherwise, screw sockets might
be worn. Check that oven doesn't
move after mounting. If oven
isn't mounted in accordance with
instructions, there is a risk of tilt over
during operation.

Electrical Connection

Mounting place of the product must have
appropriate electrical installation.
Network voltage must be compatible with the
values provided on type label of product.
Product connection must be made in
accordance with local and national electrical
requirements.
Z Z
Before starting the mounting disconnect
network power.
Z Z
Do not connect the product to network until
its mounting is completed.
WARNING:This oven must be installed
and connected to its place correctly according
to manufacturer instructions and by
an authorized service.

Control panel

1. Function Knob
2. Thermostat
GN 42 ST XS
WARNING: Appliance must be
installed in an oven enclosure providing high
ventilation.
WARNING: Electrical connections of
the appliance must be made only via sockets
having earth system furnished in compliance
with rules.
Z Z
Contact an authorized electrician if there
is no socket complying with the earthed
system at where appliance will be placed.
Manufacturing company is by no means
responsible for damage resulting from
connection of non-earthed sockets to
appliance.
Z Z
Plug of your oven must be earthed; ensure
that socket for the plug is earthed.
Z Z
Plug must be located in a place that can be
accessed after installation.
CAUTION: Your oven has been manufactured
as 220-240 V 50/60 Hz. AC power supply
compliant and requires a 16 Amp fuse.
If your power network is different that these
indicated values, refer to an electrician or your
authorized service.
CAUTION: When you need to replace the
electrical fuse, please ensure that electrical
connection is made as follows:
– Brown = Live
– Blue = Neutral
– Yellow/Green = Earth
Oven disconnecting switches must be in an
accessible place for final user while oven is
in its place.
– 9 –
EN