Oven Cleaning; Oven Door; Replacing The Oven Lamp; Assistance And Original Replacement Parts - Franke DPM 86M XS Mode D'emploi Et Installation

OVEN CLEANING

CLEANING SAFETY
Switch the oven off and wait until all the heating elements are cold before touching or cleaning them.
Carefully clean the electrical appliance.
CLEANING THE SURFACE
Use a moist cloth with non-abrasive detergent, then dry with a soft rag. Only use plastic spatulas or a sponge
with vinegar and lukewarm water to remove grime from stainless steel parts.
Important: Do not use steam cleaners on any part of the oven.

OVEN DOOR:

To remove or refit the Oven Door, carry out the following instructions;
REMOVE THE OVEN DOOR:
Open the oven door completely. – Lift the hinge hook and insert it in the locking support on both hinges, see
figure 5. This will prevent sudden closing of the hinge during door removal. – Grip the sides of the door
towards the bottom. – Lift the door a few inches (the spring will offer a certain amount of resistance due to
locking of the hinge). – When the door is raised enough, the hinges can be lifted out of their grooves. – Pull
the hinges out through the openings in the oven trim.
REFIT THE OVEN DOOR:
Grip the sides of the door towards the bottom and insert the hinges in the openings in the front trim of the
oven, see figure 5. With the oven door completely open, release the locking hooks. Lift the oven door and
make sure it was properly fitted and aligned with the side edges.
IMPORTANT. Do not remove the door locking hooks from their grooves when the door is removed. Do not
close the hinges without the weight of the door, otherwise the strong springs will violently close the hinges.
CAUTION: Do not apply excessive weight or stand on the door. This could break the door or injure the user.
Do not use the oven until the door has been properly refitted.

REPLACING THE OVEN LAMP

IMPORTANT: To prevent electric shocks and/or injury, read and carry out the following procedure:
Before replacing the oven lamp, make sure the power is disconnected by turning off the main switch.
Make sure the oven and lamp are cold. Then remove the lamp cover "A" by unscrewing it. Figure 6.
Do not touch the hot lamp with a damp cloth, as it may break.
Replace the lamp with another one suitable for electrical appliances of 25 W for 220 - 230 Vac. Figure 6.
If the lamp cover is damaged or broken, do not use the oven until the cover has been replaced or properly
refitted.

ASSISTANCE AND ORIGINAL REPLACEMENT PARTS

Only authorised components can be used on the electrical appliance. Do not repair or replace any oven
component not recommended in this manual. All other operations or repairs must be carried out by
authorised technical personnel.
When ordering a replacement part, specify the following data:
1) Oven model abbreviation and production number, given on the product label at the bottom front of the
oven cooking compartment.
2) Description and number of replacement part, technical information only available to the authorised after-
sales service.
3) Specify the details of the distributor that sold the oven, and the details of your nearest service centre.
4 9880020300 I FRANKE 050508