9. Multiple Spanning Tree Protocol (MSTP) Management
9.3 STP Port Configuration
Follow the below steps to configure the STP port:
1. Select the Instance Bridge ID that was created above
2. Select Port Fast (default: OFF)
3. Select Auto Edge (default: ON)
4. Select BPDU Guard (default: OFF)
5. Select BPDU Filter (default: OFF)
6. Select TC Guard (default: OFF)
7. Select Priority from 0-240; must be entered in multiples of 16 (default: 128)
8. Select Path COS to Auto or 1-200000000 (default: Auto)
9. Set Point to Point to ON, OFF, or AUTO (default: OFF)
10. Set Compatibility Mode (default: OFF)
11. Set Root Guard to Root or None (default: None)
12. Set TC Ignore (default: OFF)
13. Click "Save"
14. Click Show Current Port to view STP current port information
Figure 9.4: STP Current Port Information
46