Important For Installation - Sentiotec Wave.com4 Instructions D'installation Et D'utilisation

Instructions for assembly and use, only for experts
If the key is pressed again during this time, the software version number of the
operating unit is displayed with a preceding"P" (P for panel, to distinguish it from the base unit),
e.g. "P14".
If you operate the operating unit in Single/Mastermode (without base unit), only the operating unit
version is displayed.
After the 3 seconds has elapsed, the display automatically reverts to stand-by mode.
5.0.0

IMPORTANT FOR INSTALLATION

This description is supplied with the
assembly instructions for the sauna
cabin.
Observe all cabin assembly instructions.
The control unit may only be electrically
connected by authorised specialist
personnel in accordance with the
provisions of local power companies.
Only use the original parts.
Note that standard EN60335-2-53, table
101 prescribes a maximum heater power
rating regardless of the room size.
The control unit may only be connected subject to strict compliance with these
instructions.
Only use the original cable and original components supplied. Only these
components ensure strict compliance with the standards (wire cross-section,
insulation, temperature class, etc.)!
Inspect all electrical cables for damage before and after installation.
Ensure that all damaged leads/cables are immediately replaced by a qualified
specialist or service company.
sentiotec GmbH accepts no liability for damage or consequential damage caused by
damaged components or the utilisation of non-original components!
The control unit is only ready for operation
when all electrical and construction works
are complete.
WE DO IT FIRST.
42 /228