Wave.com4 Sauna- Default Settings - Sentiotec Wave.com4 Instructions D'installation Et D'utilisation

Instructions for assembly and use
Confirm your selection with
The temperature symbol illuminates.
The sauna control unit now starts with the configurations last executed (see Point 1.3.0. of these
operating instructions) or with the standard values (factory settings).
and begins to heat with the last settings of the respective operating mode.

3.5.0 WAVE.COM4 SAUNA- DEFAULT SETTINGS

Operating mode:
AutoDisplay:
Remote start:
Timer beep:
Water deficiency beep:
Target temperature:
FIN
HUM
Temperature rectification:
Humidity rectification:
Airing programme:
Target temperature:
Drying time:
Switch-on time (maximum):
Automatic switch-on:
1 hour
OFF
WE DO IT FIRST.
.
FIN
OFF
OFF
ON
OFF
75° C
50%
0° C
0%
80° C
• Heating + ventilator [15 minutes]
• Ventilator [15 minutes]
4 hours
24 /228