Manual Operation: Setting Colour; Switching Off Colour; Multiple Colour Operating Units - Sentiotec Wave.com4 Instructions D'installation Et D'utilisation

Instructions for assembly and use
The keys enable you to lengthen or shorten the interval time. Each change is then made with
this programmed standard interval time.
You can revert to "colour automatic mechanism time" with the
these operating instructions).

4.6.0 MANUAL OPERATION: SETTING COLOUR

As soon as you switch on the control unit, the
operation) symbols illuminate.
The digit displayed shows you the active colour (see Point 3.1.0 of these operating instructions).
You can change the colour with the
colour is selected or you switch off the control unit.
The key allows you to switch into "colour automatic mechanism mode" (see Point 3.4.0
of these operating instructions).
The key switches the device off.

4.7.0 SWITCHING OFF COLOUR

You can switch off the colour control by pressing the
Only the left symbol
activated operating state (automatic or manual mode). When the colour control is switched back
on again the last executed configuration is executed.

4.8.0 MULTIPLE COLOUR OPERATING UNITS

In order to be able to use several Wave.com4 sauna control units, you must assign each operating
unit its own address. Each operating unit is assigned the address "0"at the factory.
It is possible to allocate addresses from 0 to 3.
It is possible to change the address as follows:
WE DO IT FIRST.
keys. The newly selected colour illuminates until another
(ready for operation) illuminates. The colour control stores the last
(ready for operation) and
key.
key (see Point 3.4.0 of
(manual
39 /228