Mounting Of The Humidity Sensor (Optional: Only Wc4-H-Pcb); Mounting Of The Bench Sensor - Sentiotec Wave.com4 Instructions D'installation Et D'utilisation

Instructions for assembly and use, only for experts
2.3.2 Mounting of the humidity
sensor (optional: only WC4-H-PCB)
Mount the humidity sensor WC4-H-H (3-
wire) at the centre of the lateral wall further
from the heater at a height of approx. 1.5 m
(see Figures 10 and 11). The sensor cables
are also conducted through the cabin wall
here.

2.3.3 Mounting of the bench sensor

The bench sensor (2-wire) is attached to the
ceiling above the rear recliner bench (see
Fig. 11).
Drill through the cabin ceiling with the aid of
an 8 mm drill in accordance with Figure 9.
Install the sensor cables through the shaft
which has just been drilled.
Ensure that no cable is damaged
when feeding in the sensor
cables.
You can recognise the respective circuit (temperature sensor circuit or temperature
limiter circuit) from the marking on the sensor cables
WE DO IT FIRST.
Figure 27: mounting of humidity sensors
Bench sensor
Heaters sensor
Figure 28: mounting bench sensors
Heaters sensor
Humidity sensor
Humidity sensor
18 /228