Instructions For Assembly And Use; Technical Data; Wc4-B-L Power Unit - Sentiotec Wave.com4 Instructions D'installation Et D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Instructions for assembly and use

7.0.0

TECHNICAL DATA

7.1.0 WC4-B-L POWER UNIT

Mains connection
Connection operating unit
Control voltage
Mains cable
Light connection
Heating connection
Thermal fuse
Temperature sensor
Positioning accuracy
Power consumption
Ambient conditions
Casing
Fastening
Dimensions: L x W x H
Weight
WE DO IT FIRST.
For 3 x 400 V ~ 50 Hz with L1-L2-L3-N-PE; 1 x 230 V ~ 50 Hz
with L-N-PE; casing only for standard domestic connection with
fuse and residual current device and main switch.
The main switch must have a contact opening of at least 3 mm!
4-pole with 5 V= supply and communication; length: 3 m
Low voltage 5 V=
Typical 5 x 2.5 mm² for heater (cross section see 6.1.0)
Typical 3 x 1.5 mm² for light and electronics
With integrated phase control dimmer, for 2 (3)-pole connection
of the 230 V filament lamp(s); max. 100 W
3 x 400 V~ 5-pole according to heater power rating up to max. 3
kW or 14 A per phase
Integrated into the temperature sensor as overtemperature
protection; triggering temperature 139 ° C
2-pole; semiconductor sensor -9 ° C to 140 ° C
+/- 1 ° C; +/- 1 min.
Operating mode FIN:
Operating mode HUM:
and max. 1 x 3 kW (evaporator)
For light:
max. 100 W
0 ° C to max. 50 ° C, max. 95 % rel. humidity, not co ndensing!
IP54
Via 4 mounting holes for M3 for screwing on
300 x 210 x 100 mm
~1114 g unpacked
max. 3 x 3 kW (heater)
max. 2 x 3 kW (heater)
54 /228

Publicité

Table des Matières
loading

Table des Matières