Programming Master/ Slave Operating Unit - Sentiotec Wave.com4 Instructions D'installation Et D'utilisation

Instructions for assembly and use
6. Unplug the RJ10 4/4 (bus/supply cable) of the operating unit.
7. Keep the
8. Plug the RJ10 4/4 supply cable of the operating unit in again (keep the
down).
9. This will take you to the address allocation menu. The address currently allocated to your
operating unit is displayed here.
10. Change the address with the
Confirm your entry with the
the advanced "Master/Slave colour operating unit programming" menu (see Point 3.9.0 of these
operating instructions).

4.9.0 PROGRAMMING MASTER/ SLAVE OPERATING UNIT

The operating unit can be used in two operating modes:
- Slave operation:
Select "SLA", standard setting, with sauna base unit as master.
This mode must be used for the control of the colour relay module
Single/Master operation:
Select "SIN", without sauna base unit.
Setting for pure colour-LED-control without sauna function (see Colour LED module
operating instructions)
Make your selection with the
Confirm your selection with the
reach the advanced "LED/REL-Menu programming" menu (see Point 3.10.0 of these
operating instructions).
WE DO IT FIRST.
keys pressed down simultaneously.
keys.
key. By your entry with the
or
key. By your entry with the
keys.
keys pressed
key you can reach
key you can
40 /228