Programming Of The Acoustic Signal - Sentiotec Wave.com4 Instructions D'installation Et D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Instructions for assembly and use
3.12.5

Programming of the acoustic signal

You can activate/deactivate the acoustic signal (produced by the integral buzzer on the base
board):
Change to the time symbol
By simultaneously pressing the
programming the acoustic signal. You can now see the number of the operating mode on the
operating unit:
Unit
Operating mode
0
1
Hourglass (= standard)
2
Water deficiency
Hourglass + water
3
4
Remote control +
5
Change to the desired operating mode with the
Confirm your selection either with the
3.12.5.1
Remote start (only for experts)
You are acting at your own discretion. Please observe the standard regulations in
this regard.
Remote start can only be executed with the optional humidity expansion board
WC4-H-PCB.
Remote start requires Port Res.5 on component WC4-H-PCB. As this port is used
inter alia for the water deficiency function of the evaporator (if the combi operation of
the sauna is desired), remote start cannot be used when Res.5 is used by the water
deficiency function of the evaporator
WE DO IT FIRST.
with the
keys for at least 3 seconds you reach the settings menu for
Soft
deficiency
Remote control
hourglass
key.
Function
No acoustic signal
Hourglass active for 1 sec. after time
elapsed
Continuous tone in the event of water
deficiency
Both signals active
See Point 3.12.5.1 and 3.12.5.2
See Point 3.12.5.1 and 3.12.5.2
keys.
key or the
key.
30 /228

Publicité

Table des Matières
loading

Table des Matières