Hourglass: Change To Time Interval - Sentiotec Wave.com4 Instructions D'installation Et D'utilisation

Instructions for assembly and use
Using these components enables your Wave.com4 sauna control unit to regulate
according to an exact temperature value (regulation according to the bench sensor).
You have the option of correcting the temperature value displayed. This is possible within a range
of ±9° C. Proceed as follows to do so:
Change to the
Press and hold the
The symbol flashes when the
press and hold the
Your value inputted here corresponds to ∆t in the graphic below.
A temperature rectification value of "0" is set as standard.
Figure 31: temperature rectification
3.12.4

Hourglass: change to time interval

Change to the
specify here with the
acoustic signal sounds (programming see Point 3.12.5 of these operating instructions).
WE DO IT FIRST.
symbol (thermometer symbol) with the
keys. This enables you to access the temperature settings menu.
keys are pressed simultaneously for at least 3 seconds. Then
and keys to confirm your selection.
measured
temperature
Advisable
temperature
symbol (time symbol) with the
keys is counted backwards. When this specified time has elapsed an
key.
key. The time (minutes) which you
29 /228