Cleaning The Mixing Unit; Changing The Intake Filter - Zhermack ELITE MIX Manuel D'utilisation Et D'entretien

CLEANING
8.1
The machine exterior can normally be kept clean just by wiping it with a dry cloth. If necessary, wet the
cloth just a little water or use a non-degreasing detergent.
The operator must ensure that the machine is kept clean and free from any foreign bodies such as
dirt, water, non-conducting liquids etc.
The machine must be cleaned at the end of every work session to remove all residues. Cleaning must
be done with the machine at standstill and positioned in a stable manner.
Before cleaning the machine exterior always turn the main switch to OFF. It is strictly
forbidden to clean the machine while it is connected to the mains power supply.
Never use inflammable, corrosive, alkaline or toxic liquids when cleaning the machine.
Eye goggles and a face mask must be worn when using compressed air for
cleaning purposes. Do not allow any persons near the machine as they could be hit by
flying dust.

8.1.1 Cleaning the mixing unit

Once mixing is over it is necessary to clean the components (lid with spatula and cup).
Wash them with plenty of water.
Do not use alcohol or solvents to clean mixing unit components.
Apply Vaseline to the rubber seals on the lid every now and then.
This will make the seals last longer and also ensure optimal vacuum
performance.

8.1.2 Changing the intake filter

16
Figure
124 of 264
CHAPTER 8: MAINTENANCE
Fig. 16: The pre-filter is located on the inner side of the
mixer unit support; change it with the aid of the supplied
key.
MAINTENANCE AND USE MANUAL
EN
Do not use the machine without the
filter.
ELite mix