Mode Selection - Masimo Rad-G Manuel De L'utilisateur

OPERATION
The information in this chapter assumes that Rad-G is set up and ready for use. This chapter provides necessary information for proper operation of
the device. Do not operate Rad-G without completely reading and understanding these instructions.

Mode Selection

After the Rad-G is powered ON, select either Spot Check Mode or SpO2/Respiration Rate Screening. The mode can be selected only at power ON. The
mode can be changed only if the device is powered OFF and ON again.
MODE SELEC TION
Accessing Main Menu Options
To access Main Menu options, touch the Main Menu button on the bottom-right corner of the touchscreen. See Front View section.
To exit the Main Menu, touch the Home Button or the Backward Navigation button.
The Main Menu options are:
MAIN MENU OPTIONS DISPLAY BUTTON
Manual
Sounds
Display
Date and Time
About
Performing SpO2/Respiration Rate Screening
To perform SpO2/Respiration Rate Screening, the Rad-G must be powered ON with the battery charged and the sensor must be connected to the
device (See Directions for Use for sensor).
1. If the Rad-G is powered OFF, press the power button ON.
Note: If Rad-G is already ON and in Spot Check Mode, cycle the the power OFF and ON to change modes.
2. Touch SpO2/Respiration Rate Screening mode.
3. Touch the SpO2/Respiration Rate Screening home screen.
4. Select the age of the patient.
5. Touch Next.
6. Place the sensor on the patient (See Directions for Use for sensor).
7. Touch Start to begin the SpO2/Respiration Rate Screening. Rad-G searches for a pulse and changes to a measuring screen.
The screening result is either negative or positive. See the table below.
8. Touch Done to complete the screening.
RESULT DISPLAYED
REF. FEATURE
1 Music Enabled
2 Voice Enabled
3 Rad-G Battery Charge/AC Power Indicator
4 Current Time
5 Spot Check Mode
6 SpO2/Respiration Rate Screening Mode
Displays web address to obtain operator's manual: http://techdocs.masimo.com/
Controls the Music and/or Voice volume.
Brightness - Controls the brightness of the display screen.
Enable animations - Allows animation to be turned ON or OFF
Set the current date and/or current time.
Shows the device's software version information as well as serial number.
These details may be helpful during troubleshooting or when contacting Masimo
for assistance.
DESCRIPTION
The "screen negative" message has green font to indicate
SpO2 is greater than or equal to 90% and RRp is less than
the age specific criteria. See SpO2/Respiration Rate
Screening Criteria.
Screen negative conditions are met ONLY when SpO2 is
greater than or equal to 90% and RRp is less than the age
specific criteria.
INFORMATION
Displays when music volume is set to Low, Medium, or High.
See Accessing Main Menu Options to change the music volume settings.
Displays when voice volume is set to Low, Medium, or High.
See Accessing Main Menu Options to change the voice volume settings.
Displays battery charge status and percentage.
See Initial Battery Charging section and AC Power Indicator section.
Displays the current time. See Accessing Main Menu Options section to change
the time.
See Spot Check Mode section.
See SpO2/Respiration Rate Screening section.
DESCRIPTION
RESULT DISPLAYED
8
DEFAULT OPTIONS
N/A N/A
High Off, Low, Medium, or High
100% 25%, 50%, 75%, or 100%
On On/Off
N/A N/A
N/A N/A
DESCRIPTION
The "screen positive" message has red font to indicate
SpO2 is less than 90% and/or RRp is greater than the
age specific criteria. See SpO2/Respiration Rate
Screening Criteria.
The out of range value will be highlighted red.
39296/9527H-0320