General Maintenance; Troubleshooting - MINN KOTA 1355920 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

GENERAL MAINTENANCE

GENERAL MAINTENANCE
• After use, the entire motor should be rinsed with freshwater, then wiped down with a cloth dampened with an aqueous-based
silicone spray. Do not spray water into the ventilation openings in the head of the motor.
• The composite shaft requires periodic cleaning and lubrication for proper retraction and deployment. A coating of an aqueous
based silicone spray will improve operation.
• The propeller must be inspected and cleaned from weeds and fishing line after every use. Fishing line and weeds can get behind
the prop, damage the seals and allow water to enter the motor.
• Verify the prop nut is secure each time the motor is used.
• To prevent accidental damage during transportation or storage, disconnect the battery whenever the motor is off of the water. For
prolonged storage, lightly coat all metal parts with an aqueous based silicone spray.
• For maximum battery life recharge the battery(s) as soon as possible after use. For maximum motor performance restore battery to
full charge prior to use.
• Keep battery terminals clean with fine sandpaper or emery cloth.
• The propeller is designed to provide weed free operation with very high efficiency. To maintain this top performance, the leading
edge of the blades must be kept smooth. If they are rough or nicked from use, restore to smooth by sanding with fine sandpaper.
• Inspect the Pull Grip and Cable and Hold Down Strap before each use and replace if they shows signs of wear.

TROUBLESHOOTING

1.
Motor fails to run or lacks power:
• Check battery connections for proper polarity.
• Make sure terminals are clean and corrosion free. Use fine sandpaper or emery cloth to clean terminals.
• Check battery water level. Add water if needed.
2.
Motor loses power after a short running time:
• Check battery charge. If low, restore to full charge.
3.
Motor is difficult to steer:
• Loosen the steering tension knob on the bracket.
• Lubricate the composite shaft.
4.
You experience prop vibration during normal operation:
• Remove and rotate the prop 180°. See removal instructions in the Propeller Replacement section.
5.
Experiencing interference with your fishfinder:
• You may, in some applications, experience interference in your depth finder display. We recommend that you use a separate deep
cycle marine battery for your trolling motor and that you power the depth finder from the starting/cranking battery. If problems still
persist, call our service department at 1-800-227-6433.
NOTICE:
For all other malfunctions, visit an Authorized Service Center. You can search for an Authorized Service Center in your
area by visiting our Authorized Service page, found online at minnkotamotors.com, or by calling our customer service number at
800-227-6433.
22 | minnkotamotors.com
©2021 Johnson Outdoors Marine Electronics, Inc.

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Riptide edge

Table des Matières