Troubleshooting & Repair; Troubleshooting The Copilot - MINN KOTA RIPTIDE SP Manuel De L'utilisateur

TROUBLESHOOTING & REPAIR
TROUBLESHOOTING THE MOTOR
1. Motor fails to run or lacks power:
• Check battery connections for proper polarity.
• Make sure terminals are clean and corrosion free. Use fi ne sandpaper or emery cloth to clean terminals.
• Check battery water level. Add water if needed.
2. Motor loses power after a short running time:
• Check battery charge. If low, restore to full charge.
3. You experience prop vibration during normal operation:
• Remove and rotate the prop 180°. See removal instructions in the Propeller Replacement Section.
4. Experiencing interference with your fi shfi nder:
• You may, in some applications, experience interference in your depth fi nder display. We recommend that you use a separate
deep cycle marine battery for your trolling motor and that you power the depth fi nder from the starting/cranking battery. If
problems still persist, call our service department at 1-800-227-6433.
NOTE: For any other malfunctions, visit an Authorized Service Center. You can search for an Authorized Service Center in your
area by visiting our Authorized Service page, found online at minnkotamotors.com, or by calling our customer service number at
800-227-6433.

TROUBLESHOOTING THE COPILOT

CAUSE
Remote is not transmitting.
When receiver is powered up, it sounds a
beep pattern (1 long beep, 2 short beeps,
pause, repeat).
The prop is not turning but the PROP ON
audio tick is still going.
©2015 Johnson Outdoors Marine Electronics, Inc.
EFFECT
The battery is discharged.
Receiver may not have "learned" the ID
number of the remote.
With the foot pedal connected, the MOM-
CON switch is in the CON position. An audio
response will be heard if a button is pressed
with the foot pedal in the CON position.
If remote has been taken apart, the keypad
and top case may have been installed
backwards.
The foot pedal MOM-CON switch is in the
CON position.
Prop Speed is set at "0".
PROP ON tick occurs only in Audio Mode 3
SOLUTION
Replace battery.
Remote needs to be learned. See "Adding/
Removing Remotes" to learn the remote ID
number.
The foot pedal switch must be placed in the
MOM position. The receiver will not accept
any commands from the remote with the
switch in the CON position.
Take remote apart (see "Replacing the
Battery") and reinstall case halves with the
proper orientation.
The foot pedal switch must be placed in
the MOM position. The beeping sound will
continue until the switch is placed in the
MOM position.
Increase the prop speed above "0"
Switch Audio Mode to either Audio 1 or 2.
See "Audio Modes".
minnkotamotors.com | 17