Closing The Control Unit; Standby/Reactivating The Control Electronics; Obstacle Detection; User Training - SOMFY SGS LINE Manuel D'installation

2.4 Closing the control unit

1
Affix summary label (g) to the back of the control unit cover.

2.5 Standby/Reactivating the control electronics

Once the auto-programming process has been completed, the
electronics automatically switch to standby a er 5 minutes of
inactivity to save energy.
In standby mode, all indicator lights are off.
2.6 Completely opening and closing the gate
The remote controls supplied with the kit are already memorised
and programmed so that button 1 on the remote controls activates
complete opening of the gate.

2.7 Obstacle detection

If an obstacle is detected (abnormal force on the motorisation):
• When the gate is opening: the gate will stop.
• When the gate is closing: the gate will stop and reopen.

2.8 User training

All users must be trained on how to safely use this motorised gate (standard use and unlocking principle) and on the mandatory periodic
checks.
STOP
Commissioning and standard use
2
Close the control unit and screw in the cover.
To check whether the motorisation is switched on or to check/
modify the parameter setting, press the
reactivate the electronics. The electronics will automatically switch
to standby a er 5 minutes of inactivity.
• Gate closed: press button 1 on the remote control to open the gate
fully.
• Gate moving: Press button 1 on the remote control to stop the
gate.
• Gate open: Press button 1 on the remote control to close the gate.
EN - SGS LINE installation and operating guide - SOMFY
button for 2 seconds to
Button 1
2
21