Safety Instructions Relating To Maintenance; About The Batteries; Recycling And Disposal; Regulations - SOMFY SGS LINE Manuel D'installation

Safety instructions relating to
maintenance
The motorisation must be disconnected from any
power supply during cleaning and maintenance and
when parts are replaced.
Every month, check:
• the installation, looking for any signs of wear
or damage to the cables and assembly.
• that the motorisation changes direction when
the gate encounters an object measuring 50
mm positioned halfway up the leaf
Do not use the motorisation if it needs repairing or
adjusting. Gates in poor condition must be repaired,
reinforced or even replaced.
Use only original parts for any maintenance or
repair work.
Any technical, electronic or mechanical modification
to the motorisation must be made with the approval
of Somfy assistance.
If the installation is equipped with photoelectric
cells and/or a flashing light, regularly clean the
photoelectric cell optical units and the flashing light.

About the batteries

Do not leave batteries of any kind within reach of
children. Keep them somewhere children cannot
access. There is a risk that they could be swallowed
by children or pets. Danger of death! If this does
occur, seek medical advice immediately or go to
hospital.
Ensure that the batteries are not short-circuited,
thrown in the fire or recharged. There is a risk of
explosion.

Recycling and disposal

If installed, the battery must be removed from the
motorisation before the latter is disposed of.
Do not dispose of used remote control or other
batteries with household waste. They must be
taken to the relevant recycling points.
Do not dispose of the motorisation with
household waste at the end of its life. Return
the motorisation to its distributor or use your
local authority's special waste collection
services.
4
EN - SGS LINE installation and operating guide - SOMFY
DANGER
WARNING
DANGER

Regulations

Somfy declares
described in these instructions, when
used in accordance with the instructions,
complies with the essential requirements
of the applicable European Directives, and in
particular Machinery Directive 2006/42/EC and Radio
Equipment Directive 2014/53/EU.
The full text of the EC declaration of conformity
is available on the
www.somfy.com/ce. Antoine CREZE, Head of
Regulations, Cluses

Risk prevention

Identification of risk zones
Zone 2
Zone 2
Zone 1
Zone 3
Zone 3
Zone 4
Zone 4
Zone 5
Zone 5
Measures to be taken to counter risks
ZONE 1
Risks of impact and crushing
Solution:
Obstacle detection built into the
motor.
Photoelectric cells.
Photoelectric cells
Cellules photoélectriques
STOP
that the product
following website:
Zone 2
Zone 2
Zone 1
Zone 3
Zone 3
Zone 4
Zone 4