Installation; Measuring The Dimensions - SOMFY SGS LINE Manuel D'installation

1

INSTALLATION

1.1 Measuring the dimensions

Take the dimensions using disc (f) to determine the position of the motors on the pillars.
Note: For these measurements, the gate leaves and their hinge pins are assumed to be on the same axis.
N.B.: You must leave a minimum distance of 50 cm between the gate leaves and the fixed sections (see "Risk prevention" page 4).
Measure dimension A.
1
Transfer the measured
dimension A on the disc.
N.B
Dimensions not recommended
for gate leaves > 2 metres
The direction of fitting (e or E) of the cylinder mounting
2
bracket is stated.
Bracket direction of fitting "e" or "E"
Direction
Le -hand pillar
Take care to ensure the bracket is
fitted the right way up.
Recommended: dimension A is negative
If dimension A is negative, the gate leaf hinge is located in front of the pillar.
We recommend that you add a shim so that the cylinder mounting bracket
is aligned with the gate leaf hinge and A is 0 cm.
12
EN - SGS LINE installation and operating guide - SOMFY
Direction
Right-hand pillar
Correct Incorrect
orientation orientation
Determine dimension B
3
The maximum opening
4
angle α is indicated.
Angle
up to
Observe the maximum opening
angle given by the disc.
< 0 cm
= 0 cm