Presentation Of The Control Electronics; Prerequisites For Installation; Pre-Installation Checks - SOMFY SGS LINE Manuel D'installation

Presentation of the control electronics

A
B
C
D
E
F
G

Prerequisites for installation

Pre-installation checks

Gate
Your gate is in good condition: it opens and closes normally with ease.
It remains horizontal throughout its travel. It opens inwards towards your property.
Patte de
Mounting bracket
fixation
Renfort
Reinforcement
Reinforcements
The motors must be secured to the
horizontal reinforcements of the gate
leaves, which should ideally be positioned
1/3 up the gate.
If there are no reinforcements, use metal
reinforcement plates approximately
4 mm thick.
Pillars
The pillars must have a robust structure and be at least 21 cm wide. If they do not, improvements may have to be made to your pillar to
guarantee correct installation and to ensure that the bracket stays in place.
It is not recommended to mount the bracket level with the pillar: risk of spalling.
No. Description
A
Button
RADIO indicator
B
light
Indicator light
C
Indicator light
D
Indicator light
E
P1
RESET indicator
F
light
Indicator light
G
Closing end stops on the ground
The gate's closing travel must be defined
by end stops firmly fixed in the ground.
The opening stops are integrated in the
motor (see "Adjusting the opening stop"
page 19).
Function
Reactivation of the control electronics
Lights up each time the control electronics receive a
radio command
Lights up during activation/deactivation of the
pedestrian opening
On automatic closure of the gate is activated
automatic closure of the gate is not
Off
activated
the "automatic closing" parameter is
Flashing
selected
Not used
the settings alone or the settings and the
On
radio control points are deleted
the settings and radio control points deletion
Flashing
function is selected
the motorisation functions correctly - the
On
control electronics are reactivated
the motorisation functions correctly - the
Off
control electronics are in standby
Flashing see "Diagnostics" page 31
Mechanical lock
If the gate is equipped with a mechanical
lock, it must be removed.
EN - SGS LINE installation and operating guide - SOMFY
9