Installing The Control Unit; Position Of The Control Unit; Installing The Sealing Strip; Checking The Position Of The Antenna - SOMFY SGS LINE Manuel D'installation

1 Installation

1.4 Installing the control unit

Position of the control unit

The unit will be mounted on a pillar/wall on the side where the
power supply arrives.

Installing the sealing strip

Fit sealing strip (m) inside the top of the control unit.

Checking the position of the antenna

For optimum performance, it is essential that the antenna is
correctly positioned.
Do not cut the cut the antenna wire.

Securing the control unit

1
2
16
EN - SGS LINE installation and operating guide - SOMFY
230V
Antenna
• Position the unit mounting bracket (p) against the pillar/
wall.
• Check that it is horizontal by placing a spirit level in the
intended location.
• Mark the mounting points for the bracket.
Remove the bracket and drill the pillar/wall. The drilling
diameter is to be defined based on the type of screws used
for mounting (see page 11).