Installation; Assembling The Manual Release Handle; Unlocking The Motor; Installing The Motorisation - SOMFY ELIXO 500 3S io Manuel D'installation

iNstallatioN

The motorisation must be disengaged during installation.

assembling the manual release handle

[1]. Insert the release handle into the specific housing on the motor.
[2]. Tighten the release handle.
[3]. Fit the screw cover.

unlocking the motor

[1]. Turn the key a quarter of a turn to the left.
[2]. Turn the release handle to the right.
Do not forcibly push the gate. Hold the gate over its entire travel during manual manoeuvres.

installing the motorisation

fitting the mounting system
The motor mounting kit provided is to be used on a concrete base. For all
other types of mounting, use the appropriate fittings.
[1]. Position the base plate:
• parallel to the gate,
• with the symbol on the pinion pointing towards the gate,
• by moving it by 25 mm in relation to the front line of the rack (if the rack is
fitted with a cover, measure from the line on the rack, not on the cover),
• so that it does not obstruct movement and to ensure the gate is able to
open and close completely.
[2]. Mark the location for the ground mountings.
[3]. Drill to a depth of 85 mm.
[4]. Insert the plugs.
[5]. Tighten the lag screws on:
• the threaded section for a rack height of between 110 and 130 mm,
• the threaded section + the unthreaded section for a rack height of
between 100 and 110 mm.
To facilitate tightening of the lag screws, use 2 nuts to
form a "double nut".
[6]. Screw a nut onto each lag screw.
[7]. Place the base plate onto the lag screws with the symbol on the pinion
pointing towards the gate. It must be a minimum of 23 mm from the
ground.
Copyright © 2012 Somfy SAS. All rights reserved
14 mm
100 mm<h<110 mm
h
100 130
25
Elixo 500 3S io
60 mm
20 mm
110 mm<h<130 mm
55 mm
5