Table des Matières
Publicité
Electric wire rope winch BETA EL
English
4.11 Operating Elements:
The operating elements (operating places) have to
be installed in such a way that the entire load dis-
tance can be overlooked from the operator's position.
Push buttons have to be located in reasonable posi-
tion.
Protective measures:
Connection, protective measures and safety precautions have to be effected according to
local, national and international regulations.
Before taking into operation, check:
correct polarity, turning direction, placement of order devices
protective conductor system
insulation resistance
overload protection adjustment (if existing)
function
5
Operation
Before taking into operation please turn on the main switch.
The required direction is to be initiated by pressing the respective push-button Up
For el. wire rope winches with 2 rope speeds the push-buttons Up-Down are step push-buttons.
1st step (half pressed) slow speed
2nd step (completely pressed) quick speed
During operation, the operator always has to observe the load, the room below and above the
load and the load carrying device.
For safety instructions see page 24
In case of occurring faults, immediately stop operation and eliminate the fault.
Always pay attention to correct turning direction of the rope drum.
Never coil up the rope incorrectly.
When overload protection is effective, reduce the load.
In case of danger operate the Emergency-Stop switch.
5.1 Direct control
Direct control up to max. 980 kg
max. driving power 2,2 kW
Main switch (see page 33) and
motor protection provided on site (see page 43)
technische Änderungen vorbehalten
design changes under reserve
04.01.401
lifting
lowering
emergency-stop
lowering
changements techniques sous réserve
lifting
lowering
emergency-stop
- Down .
Emergency
stop
lifting
35
Publicité
Table des Matières
