A.3 Ce Directives; A.3.1 Compliance With Safety Standards; A.3.2 Environmental Conditions; A.3.3 Worn Devices - AOIP CALYS 50 Mode D'emploi

A.3 CE directives

A.3.1 Compliance with safety standards
The unit complies with applicable standards:
- Safety directive 2006/95/CE with standard EN611010-1
- Directive CEM 2004/108/CE with standard EN61326-1
These instructions for use contain information and warnings which must be observed by the user to protect the latter
against the dangers of electricity, to ensure the safe operation of the device and to protect it against any mishandling
which could damage or compromise the safety of use of the device.
A.3.2 Environmental conditions
In accordance with publication CEI 359: operating category I.
Range of application of standards: from 0 to 2,000 m.
Reference temperature range: 23°C ± 5°C, relative humidity: 45 % to 75 %.
Nominal operating range: -10°C to +50°C, relative humidity: 20 % to 80 % non-condensing.
Operating range limit: -15°C to +55°C, relative humidity: 10 % to 80 % (70 % at 55°C).
Storage and transport temperature range limit: - 30°C to + 60°C (without the batteries).
A.3.3 Worn devices
Worn electrical devices can pollute the environment. We recommend you refrain from disposing of this device in an
ordinary waste bin, but rather that you use the recycling circuits available locally. If not, you can return the device to us,
and we will take care of its disposal free of charge.
A.3.3.1 Waste generated by the device
List of waste classified according to the decree published in the Official French Gazette dated 20
2002-540.
16.02.14: Waste originating from electronic equipment:
Printed circuit boards making up the device
16.06.02: Batteries and storage battery (dangerous)
LiPo battery (Lithium Polymere 7.4 V).
3 V lithium battery (CR1225 type)
15.01.02: Packaging
ABS plastic and polycarbonate device casing
Elastomer sheath
A.3.4 Device destruction procedure
Opening the device: unscrew the screw on the battery compartment, followed by the 5 screws securing the 2 shells.
Separate the 2 shells. Separate the PCB from the upper shell.
With regard to the batteries, you will find them in the battery compartment (see commissioning chapter).
A
CE directives
th
April 2002. Decree no.
NTA47227-300A8 95 / 164